ESP32

2023-05-20 13:22| 来源: 网络整理| 查看: 265

ESP32 型号：ESP32-S3-WROOM-1(M0N8R2)

ESP32 烧录器型号：ESP Prog v1.0 IOTMCU

烧录器的开关按键是复位按键。

接线图如下：

注意：RX连 RX TX连TX EN连RST

Arudion IDE 配置如下：

注意 Arudino 中使用串口为 Serial0.

VsCode PlatformIO 配置如下：

[env:esp32s3box] platform = espressif32 ;board = esp32s3box board = esp32-s3-devkitc-1 framework = arduino upload_port = COM9 upload_speed = 115200

Vscode 代码如下：

#include #define LED_BUILTIN 1 // the setup function runs once when you press reset or power the board void setup() { // initialize digital pin LED_BUILTIN as an output. pinMode(LED_BUILTIN, OUTPUT); Serial.begin(115200); } // the loop function runs over and over again forever void loop() { Serial.println("esp32-s3 running..."); digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }

加作者微信：jiyuyun18（积雨云）, 交流电子技术

留言：ESP32, 加入 ESP32 技术讨论群

【本文地址】

公司简介

联系我们